Taulman BluPrint is a filament claiming to print strong parts that are very heat resistant.
High heat resistance means high print temperatures for most plastics so this prints at a minimum of 265ºC depending on which website you believe. Taulman’s website says 285C is the recommended Print temp.
They also claim that glass heated to 110C is the right print surface. I find it hard to believe that plain glass will hold onto any plastic so my first attempt was using Wolfbyte for Nylon. The filament was printing well at 265-280ºC but after a few layers (10) promptly removed itself from the print bed and tried to cause a big mess. I was there to cancel before any real harm was done.
Next I’m testing glass with hair spray. Heated to 110ºC and with a fresh generous application of hairspray. It’s held strong much farther along than the Wolfbyte which makes me think it may not be a nylon based material. Perhaps it’s a PC derivative which generally prints at much higher temperatures.
After 1 hr 45min the corners of the 4×4 rectangle are showing noticeable curling. A 3 pass brim was added for the first layer but has pulled up from the bed. The front of the printer is not enclosed for this test and only the front 2 corners are peeling.
The print finished and didn’t completely detach from the build plate after 3hr 41min build time. Although it was close to detaching. Final weight is 3.8 ounces or 108 grams.
2nd part test print adjusted the bed temp to 120ºC. 4×4 square is not extruded as high and should have less issues with warping. Increased the brim to 5 passes roughly 3.5mm. I also closed the front of the printer
The part appeared to be well attached to the print bed for the entire print. Minimal signs or warping on the corners. By the time I checked the printed the build plate had cooled and the part completely released from the glass with hairspray.